AQUA PROTECT + - universal agent for imparting hydrophobic properties to mineral porous surfaces (paving stones, concrete, brick, sandstone, plaster, screed, natural and artificial stone, etc.). It helps to extend the life of the surface and significantly reduces the formation of fungi and mold. The water-repellent properties of the substrate last for at least 5 - 7 years *. The agent can be added to mortars or concrete to increase the hydrophobicity of the mineral substrate.

Properties

• The agent significantly increases the water resistance of the surface
• Much higher yield than methyl siliconate products.
• Gives a "lotus" effect
• It does not affect the vapor permeability
• Does not block pores
• Increases service life
• It protects against the appearance of efflorescence and other impurities
• It does not contain solvents organic

Instructions For Use

 Before application , the surface must be thoroughly cleaned of dirt and rinsed with water. After

dry, apply AQUA PROTECT + in a thin layer with a roller or brush. The product is ready to use and does not require dilution.

The surface is ready for operation in 24 hours. Important! The tool can be used at a temperature of 5-25 ° C.

 Attention

The information contained in this technical description is correct and reflects the current level of our knowledge about the use of this product. It is a guide for optimal use and cannot be used as a warranty or specification. Due to the wide variety of uses and methods material handling and finished products it is important that our products are suitably made tested before use.